general note irc reserves the right to make changes in product speci?cation without notice or liability. all information is subject to ircs own data and is considered accurate at time of going to print. a subsidiary of tt electronics plc ? 4222 south staples street ? corpus christi texas 78411 usa ? irc wirewound and film technologies division telephone: 361 992 7900 ? facsimile: 361 992 3377 ? website: www.irctt.com d h l h d zerohm series ? 1/4 watt size ? less than 0.01 ? ? mil version available under desc dwg 87009 ? supplied on lead tape and reel for automatic insertion contact factory for ordering information. ordering data dimensions unit l d h d molded 1/4 w 0.250 0.015 (6.35mm 0.381) 0.090 0.008 (2.3mm 0.2) 1.50 0.125 (38.1mm 3.2) 0.025 nom. (0.63 nom) physical data molded zero ohm jumper wires maximum resistance 0.01 ? max lead material solder coated copper clad steel body material electrical grade, high performance, coating and molding compounds minimum insulation resistance dry, 10,000 megohm; wet, 100 megohm minimum dielectric withstanding voltage atmospheric, 500v rms; reduced, 325v rms current rating 15 amps at 70 c for 1/4w max 3a continuous packaging 5000/reel or 1000/bulk ircs jumper wires offer a quick, simple solution for circuit board point-to-point connections or crossovers. these are also used for after-the-fact design change that requires new point connections, connect two points on a circuit board due to other circuit paths which must be crossed-over, and circuit tuning by changing point connections. these are especially suited for automatic machine insertion on lead tape, and are available in all packing styles including pre-cut and formed leads for manual insertion. speci?cation data note: all parts marked with black band zerohm series issue january 2009 sheet 1 of 1
|
